13
Using control maps
By turning the Protect setting on, you can protect the control map data from being
accidentally overwritten.
This will disable All Bulk reception (p. 10) and Save (p. 9) operations, protecting your
valuable data from being overwritten.
The Protect on/off setting is remembered even when the PCR is powered off.
fig.H-Edit.eps
1
Press the [EDIT] button so it’s lit.
fig.D-Edit.eps
The display will indicate “EDIT.”
fig.D-Protect.eps
2
Turn the VALUE knob to make the display indicate “PTC.”
3
Check the indication in the display, then press the [ENTER] button.
The display will indicate the current protect status.
4
Use the VALUE knob to choose the desired setting, and press the [ENTER] button.
Protecting the control maps
Controller
Item Display Explanation
[A1 (0)] PROTECT OFF
Control map data in internal mem-
ory can be rewritten.
[A2 (1)] PROTECT ON
Control map data in internal mem-
ory cannot be rewritten.
PCR-300_500_800_e.book 13 ページ ２００６年１２月１９日 火曜日 午後２時５９分
To Next Page
Loading...
Need help?
General
