Roland EDIROL PCR-300 - RPN, NRPN, and Encoder Simulate

27
Using PCR Editor
Program Change – Inc
Assign the program change increment function (PC
INC).
This will transmit a program change number that is
one greater than the program change number most
recently transmitted in the PCR’s program change
mode.
fig.EditorPCInc.eps_35
There are no parameters to specify for Program
Change – Inc.
RPN
[Bn 65 mm Bn 64 ll Bn 06 dm Bn 26 dl]
Assign a registered parameter number.
fig.EditorRPN.eps_35
You can specify the following parameters for RPN.
* The range for the data entry LSB [dl] is fixed at 0–127 and
cannot be changed.
NRPN
[Bn 63 mm Bn 62 ll Bn 06 dm Bn 26 dl]
Assign a non-registered parameter number.
fig.EditorNRPN.eps_35
You can specify the following parameters for NRPN.
* The range for the data entry LSB [dl] is fixed at 0–127 and
cannot be changed.
Channel Message
Item
Content
MIDI Channel
MIDI channel [n]
RPN MSB
RPN parameter number
MSB [mm]
RPN LSB
RPN parameter number LSB
[ll]
MSB Min Value
Lower limit of data entry
MSB [dm]
MSB Max Value
Upper limit of data entry
MSB [dm]
Item
Content
MIDI Channel
MIDI channel [n]
NRPN MSB
NRPN parameter number
MSB [mm]
NRPN LSB
NRPN parameter number
LSB [ll]
MSB Min Value
Lower limit of data entry
MSB [dm]
MSB Max Value
Upper limit of data entry
MSB [dm]
PCR-300_500_800_e.book 27 ページ ２００６年１２月１９日 火曜日 午後２時５９分