4141
° Error Messages
Indication Meaning
Error 2
An error occurred during writing. The USB ash drive may be corrupted.
Insert other USB ash drive and try again. Alternatively, you can initialize the USB ash drive (p. 33).
The internal memory might be damaged. Format the internal memory (p. 33).
Error 3 The same le already exists.
Error 10
No USB ash drive is inserted. Insert the USB ash drive and try again.
The internal memory might be damaged. Format the internal memory (p. 33).
Error 11
There is not sucient free memory in the save destination.
Either insert other USB ash drive or delete unneeded les and try again.
Error 14
An error occurred during reading. The USB ash drive may be corrupted.
Insert other USB ash drive and try again. Alternatively, you can initialize the USB ash drive (p. 33).
The internal memory might be damaged. Format the internal memory (p. 33).
Error 15 The le is unreadable. The data format is not compatible with the unit.
Error 18
This audio format is not supported.
Use an WAV format (44.1 kHz, 16-bit linear) or MP3 format audio le.
Error 30 Internal memory capacity of the unit is full.
Error 40
The unit cannot deal with the excessive MIDI data sent from the external MIDI device.
Reduce the amount of MIDI data sent to the unit.
Error 43 A MIDI transmission error has occurred. Check the connected MIDI device.
Error 51
There may be a problem with the system. Repeat the procedure from the beginning. If it is not solved after you have tried several
times, contact Roland Support.
Error 65
The USB Memory port was subjected to excessive current. Make sure that there is no problem with the USB ash drive, then turn
the power o, then on again.
To Next Page
Loading...
Need help?
General
