10
Other S1 and S2 Switch Uses
AFTERTOUCH—• so that pressing an S button generates a value of 127 or
0 in all three modes, according to the Assign Mode setting.
MONO/POLY—
• so that the switch toggles the Mono/Poly switch for the
currently selected part in all three modes.
PFX SWITCH—
• so that the switch toggles the PFX for the currently
selected part on and off in all three modes.
MFX SWITCH—
• so that the switch toggles the input’s MFX processor on
and off in Live and Single modes.
MFX 1 SWITCH—
• so the switch toggles MFX 1 on and off in Studio
mode.
MFX 2 SWITCH—
• so the switch toggles MFX 2 on and off in Studio
mode.
CHORUS SWITCH—
• so that the switch toggles the global chorus on and
off in all three modes.
REVERB SWITCH—
• so that the switch toggles the global reverb on and
off in all three modes.
MASTERING SWITCH—
• so that the switch toggles the mastering effect on
and off in all three modes.
MASTER KEY UP—
• so that the Fantom-G’s master tuning moves up by
one semitone each time the switch is pressed.
MASTER KEY DOWN—
• so that the Fantom-G’s master tuning moves
down by one semitone each time the switch is pressed.
SCALE TUNE SWITCH—
• so that the currently selected part’s custom scale/
tuning is toggled on and off from the S switch.
Setting Up the D Beam
This parameter selects the job you’d like the D Beam to perform. It can be
set to OFF, PAD TRIGGER, SOLO SYNTH, or ASSIGNABLE. When it’s set to OFF,
no D Beam settings are displayed. When the parameter’s set to some other
value, the Fantom-G presents the available options.
When the Control Setting screen’s visible, you can press any of the D
Beam’s three buttons to jump straight to its associated parameters.
Using the D Beam as a Pad Trigger
When you use the D Beam as a pad trigger, you swipe your hand across the
D Beam sensor to “strike” the pad, and move it out of the way to stop.
Here are the D Beam’s parameters when you’re setting it up as a trigger for
one of the Fantom-G’s dynamic pads:
Beam Trigger Pad—
• With this parameter, you select the pad you’d like to
trigger from the D Beam.
Beam Trigger Velo—
• Set how hard you’d like the D Beam to “strike” the
selected pad using this parameter.
Beam Trigger Mode—
• This sets the triggering of the D Beam to
LATCH—
• so the D Beam acts as an on/off toggle for the pad.
MOMENTARY—
• so that the pad is “struck” for only as long as you
hold your hand in the D Beam.
To Next Page
Loading...
