Roland FP-8 User Manual

Power Cable
Pedal
1 Ensure that the POWER switch (rear panel) is in the ‘OFF’ position.
2 Connect the power cable to the AC inlet (and to an AC outlet).
*Use only the power cable included with the unit.
*Ensure that the voltage in your installation meets the requirements of
the
piano.
:
*If you will not be using the piano for an extended period of time,
unplug the power cable from the AC outlet.
1 Connect the foot pedal cable to the DAMPER jack. Although the
pedal can be used in either jack, please use the DAMPER jack for
the moment.
“An additional pedal (such as the Roland EV-5 or DP-6; sold separately) can ,
be used in the SOFT jack.
*An optional stand is available for this instrument (Roland FPS-8).
“Attach the music stand (included) to the piano if you wish. Refer to the
diagram on page 6.
This section explains the basic operation. If you are using a digital piano for the first time, be sure to read this
section before proceeding.
Turn the Power On
£7
1 Turn the POWER switch to the ‘ON’ position. In a few seconds the unit
will be ready to produce sound.
2 Play the keyboard and you will hear the Grand Piano sound (PIANO
variation 1 is automatically selected at power up). Notice that changes
in playing dynamics cause natural changes in the timbre and volume
of the sound.
* A protection circuit will operate for approximately 3 seconds after the power
is turned on - there will be no sound during this time.

Roland FP-8 Specifications

General

Brand	Roland
Model	FP-8
Category	Musical Instrument
Language	English