Roland GP-8 - 4. PATCH SELECTION WITH MIDI; MIDI Program Change for Patch Selection

MIDI Operation
Мота! Condition
GUITAR SOUND 57571
ж 2 жж ж n Y ж 4: :
tescare! :
H В MIDI CHANNEL ae us
:
CHANNEL
=
4
рі
1 , Н
Са! the Function to
be edited.
[BULK БЕР | DUMP -i oi
ber OP _ | ies en
BULK EU 201 рі
OEE _ -bod
n Pod
Edit the Function
BULK Ero RE HP
Ero RE
[re
Enter the edited data p
5 ЕЗСАРЕ!
В В BULK DUMP
: ALL 2
Ч
Write the edited data
Bulk Dump Data Transfer
ВВ | "se
А SAUTHG....
Transfer Ш
Completed
MIDI
4. PATCH SELECTION WITH
MIDI
The Patches on Ше СР-8 сап be externally
changed with the Program Change messages
sent from the connected MIDI device,
жіп this case, set the Selector Switch on
the rear panel of the GP—8 to the MIDI
IN position.
The Program Change numbers correspond
to the Patch Numbers (Group/Bank/
Number) of the GP—8 as shown below.
"ЕЕЕ ЕЕ
шашин
‚==
"TIRE
14155145 515
-РРРР Ч"
ENEICICICICIEICIES
ENCICICICICIEIERES
EE
[eI
ENCIEIDIEIEIEIEIEI
шаш
EIER:
БИ ЕЗ
Goo
When the Patches on the СР--8 are changed,
the corresponding Program Change number
is sent from the MIDI OUT.
27