Roland GR-1 User Manual

ide
Pano Descriptions |
SERENE
(10)
(6) ORIGINAL TONE Buttons
Used
to
assign
an
Original
Tone
to
the
Ist
or
2nd
Tone
of
a
Patch.
(7) PARAMETER Buttons
Used
tv
select
parameters
(for
editing),
or
for
switching
between
functions in the Edit mode.
(8) VALUE Buttons
In the Edit mode, use these buttons to scroll through parameter
INC | increases
button causes
values. When setting a numerical value, pressi
the value while decreases it. Holding e
the numbers to change continuously. in the Play mode. the
buttons can be used to scroll througb Patch numbers,
(9) CURSOR Buttons
Used
to
move
the
"cursor"
(flashing
character
in
the
display)
left
or right when nam a Patch, or for selecting strings in the String
mode (oP P.3-13, 4-2),
EXIT/NO | Buttons
button is used (for example? to select
ENTER/YES
ENTER/YES
functions or confirm choices. The | EXIT/NO | button is used for
returning to the Play mode from the current screen or for
and
a procedure.
* The values that you set in the Edit mode remain in effect
even after you press the | EXIT/NO | bution.
(13) (18)
(D| REVERB/CHORUS [Button
Turns the reverb and chorus effects on and off (cr P.3-9),
(2) RECORDER/PART | Button
Controls the internal Recorder ( £r P.5-1). Only the
START/STOP |hutton function in the Play mode.
P and
(13) STRING MODE Buttons
Sets whether each string will play the Ist and/or 2nd Tone
fer p.36).
(14) PATCH GROUP Buttons
Used to switch between Patch Groups (c7 P.1-91. You can select
Group
1
or
2
from
internal
memory,
or
Group
3
or
4
when
using
a
Memory Card.
(15) EDIT Buttons
Used
to
enter
the
Edit
mode
.
You
can
select
one
of
four
different
Edit modes : System { ©? P.7- D, Patch (o> P4 1). Recorder/Part
ter P,.5- D. or Write/Copy (o7 P.3-141

Roland GR-1 Specifications

General

Brand	Roland
Model	GR-1
Category	Synthesizer
Language	English