Roland GR-1 - Page 63

2. Transposing Synth Notes ‘Note Shift)
[How to: Note Shift the 2nd Tone]
This procedure ij tical io that for the ist Tone, except for the very first part.
(D press EDIT [PATCH].
The * Q" will flash.
©
This
time
you
need
five
presses
of
the
PARAMETER
|
NEXT
|
button
to
select
the
following
screen.
The * 5" will flash
@ From here, follow on just as you did with Ste: for the 1st Tone (cr P. 4-5).
* And this applies to the 2nd Tone as well: don't forget to save your settings! See Patch
Write («7 P. 3-14).
* You can change the 2nd Tone Note Shift value in the display over the range from -36 to 0
io «24. This means, since these are in units of semi-tones, that you can shift the pitch
down three octaves or up two octaves.