Roland GR-1 - Page 65

In Section 3, “Editing: Turning Reverb and Chorus On/Off” we showed vou how to make simple changes to reverb and chorus esing the
knobs on the front panel and thel REVERB/CHORVS |button. Now let's return to the subject and (ill in a few details.
First we'll explain a little about the procedure.
How to: Make Reverb Effect Settings
This is a general method for setting the various reverb "parameters" (settings that define basic
elements of the sound).
@ Press EDIT [PATER].
The * 9 "will flash
© Press the PARAMETER] PREVIOUS |button two (2) times.
The “ 9” will flash.
@ Press| ENTER/YES |.
"This is the screen for making reverb settings, so enter it
The * 2" wil stop flashing.
® Now, by pressing PARAMETER] NEXT jand | PREVIOUS |, you can step through the various
reverb parameters that you will want to set.
& The settings themselves are made by pressing the VALUE | INC [and buttons.
and
& Repeat Steps as many times as necessary to make all the settings you want.
D When you're finished, press | EXIT/NO | however many times i takes to return to the Play
mode.
* And as always, you need to save any changes you make with Patch Write (= P. 3-14)