Roland HP 147 e - Additional Safety and Compliance; Handling and Placement Precautions

AX CAUTION A CAUTION
* The unit and the power cord should be located so their * If you need to move the instrument, take note of the
location
or
position
does
not
interfere
with
their
proper
precautions
listed
below.
At
least
two
persons
are
Q
ventilation,
required
to
safely
lift
and
move
the
unit.
It
should
be
EEE E A Mei e DAGİ handled carefully, all the while keeping it level. Make
* Always grasp only the plug of the power cord when © sure to have a firm grip, to protect yourself from injury
plugging into, or unplugging from, an outlet
or this unit.
and the instrument from damage.
Check to make sure the knob bolt securing the unit to
ARS the stand have not become loose. Fasten them again
* Whenever the unit is to remain unused for an extended Q securely whenever you notice any loosening.
period of time, disconnect the power cord.
Disconnect the power cord.
Disconnect all cords coming from external devices.
Remove the music stand.
E Try to prevent cords and cables from becoming MIA ferner en DEE
A + Before cleaning the unit, turn off the power and unplug
the power cord from the outlet (p. 5).
tangled. Also, all cords and cables should be placed so
they are out of the reach of children.
unit.
* Never handle the power cord with wet hands when
S + Whenever you suspect the possibility of lightning in
your area, disconnect the power cord from the outlet. Q
m
plugging into, or unplugging from, an outlet or this N
unit.
For the U.K.
IMPORTANT: THE WIRES IN THIS MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE.
BLUE: NEUTRAL
BROWN: LIVE
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identitying
the terminals in your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED,
Under no circumstances must either of the above wires be connected to the earth terminal of a three pin plug.
For EU Countries
Ç € This product complies with the requirements of European Directive 89/336/EEC.
For the USA
FEDERAL COMMUNICATIONS COMMISSION
RADIO FREQUENCY INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 ot the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Unauthorized changes or modification to this system can void the users authority to operate this equipment.
This equipment requires shielded interface cables in order to meet FCC class B Limit.
For Canada
NOTICE
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
AVIS
Cet appareil numérique de la classe B respecte toutes les exigences du Reglement sur le matériel brouilleur du Canada.
m
=z
a
pa
un
T