Roland HP 147 e - Controls and Initial Setup; Button Descriptions

HP-147e
1. Button descriptions
Key Touch/
Piano Tone Reverb Demo Song
er
0.000
m
[Power] switch (left side panel) (3 [Reverb] button 2
Turns the HP-147e's power on and off (p. 6). Pressing this button adds reverberation to the sound sh
(D [Piano] button (p. 10). in
Pressing this button allows you to select the HP-147e's (4) [Key Touch/Demo Song] button =x
piano sound (see page 9). Hold down this button while pressing a key on the
keyboard to start the Demo Songs playing. It can also
2) [Tone] button
© [Tone] be used for making various settings on the HP-147e.
Press this button if you need another sound than the
piano that is automatically selected when you switch Note: The keys that are used in combination with this
can b x i ] x
on the HP-147e. button car be found under “Functions assigned to the key
board” on page 17.
2. Getting ready
Note: To prevent malfunction and/or damage to speakers 2 2 Opening and closing the lid
or other devices, always turn down the volume, and turn
off the power on all devices before making any connections.
2.1 Connecting the power cord
Connect the supplied power cord to a wall outlet.
Ede
* When opening the HP-147e's lid, grasp it with both
hands and gentiy lift it upwards, then slide it towards
the back of the piano.
* When closing the lid, slowly pull the lid forward, then
gently lower it into place.
Never insert your hands between the lid and the key-
Note: Strong tension applied to the cord may cause it to be board.
damaged or broken. Be careful not to pull the cord acci-
k Note: Take care not to allow fingers to be caught or
dentally, or to apply strong pressure to it.
pinched when opening and closing the lid.
Note: For safety, transport the keyboard only with the lid
in the closed position.