Roland HP 3800 - Assembling the KS-2800 Stand for the HP-2800

Assembling the KS-2800 Stand for the HP 2800
Two people are needed to carry out the assembly. Never attempt it alone.
* To move the main unit, be sure to keep it level while you lift it straight up. Be very careful, so
as to avoid getting fingers pinched, or toes hurt by accidentally dropping the unit.
M@iCheck the parts
Before you begin assembly, check that you have all the following parts.
® Side board (left) ---+++s-s++-s-rsesereeereereeereeeenes
® Side board (right) a
© Pedal board-
D Rear board --
)
@ Long screws (M6 X 60 mm)
(® Short screws (M4 X 15 mm) -
© Pointed screws (4 X 25 mm)
@ Knob bolts ervoessoosoveesooses
® Philips screwdriver
® Cord clamps
WM Assembly procedure
Attach the side boards (left and Ria ss BES TO TT TG SW to the
p E EE ET E board.
Note Extend the pedal cable out from the pedal board.
Note Be sure that the side boards (left and right) are ®
oriented correctly: the metal fittings are on the inside.
J
Fasten the pedal cord with the cord clamps; and
plug in the pedal cord and the power cord.
®© Plug the pedal cord into the jacks on the rear side of the piano.
@ Affix the cord clamps (D on the appropriate positions at the back of the
rear board (See the figure below.) then fasten the pedal cord using the
clamps.
® Plug the power cord into the rear side of the piano. (The power cord is
supplied with the piano.)
@ Use the long screws @ (M6 x 60 mm) to fasten
the side boards to the pedal board.
(Use two screws tor each side.)
Oral
B Attach the rear board.
Note Be sure that the rear board is oriented correctly: the grainy surface is on
the inside, and the black - painted surface on the outside. The end with
two through holes on the right and left ® Oey Kai
sides should be facing up. Prat
@® Use the shon screws ®©
(M4 x 15 mm) to
fasten the rear board
to the side boards.
(Use two screws for
each side.)
@ Use the pointed screws
© (4 x 25 mm) to fasten
the rear board to the
pedal board. (Use four screws.)
g Attach the piano to the stand.
Note When placing the piano on the stand, be careful not to pinch your
fingers. (Avoid holding the ends of the piano.)
g Rotate the adjusting bolt
Note If the piano is placed on carpeting, rotate the adjusting bolt a little more
so it is properly supported by the floor.
Note When placing the piano in its location, be sure not to pinch the power
cord underneath the piano.
© After the piano has been assembled and installed in its location, rotate
the adjusting bolt on the bottom of the rear board until it completely
touches the floor.
@ Align the screws (one on each side)
located on the bottom of the piano
with the slots in the metal fittings,
and slide the piano
toward the front so a A ® N
the screws ` A
slide into
position. i
(© Atter the piano si | f S
secured to the
metal fittings, —
use the two knob bolts @ to
fasten the piano to the stand. (one on each side)