Roland HP302 - Recording Performance Actions; Starting and Stopping Recording; Adding to Existing Recordings

51
Recording Your Performance
Recording and stopping
fig.Panel
1.
Press the [
] button.
You’ll hear a two-measure count, and then recording will begin.
Alternatively, you can start recording by playing the keyboard instead of pressing the [ ] button. In this case,
there will be no count-in.
When recording begins, the [ ] button and [ ] button will light.
During the count, “-2” then “-1” will be shown as the measure number in the screen.
2. To stop recording, press the [
] button.
Additional recording
fig.Panel
1.
Press the [
] button.
You’ll return to the beginning of the recorded performance.
2.
Press the [
] button.
The [
] button will light, the [ ] button and the button of the track to be recorded will blink, and the
HP305/HP302 will enter recording-standby mode.
If you decide not to record, press the [ ] button once again.
3.
Press the button of the track that you want to record, so it’s blinking.
If you decide not to record, press the [
] button once again.
If you select a previously recorded track for recording, your new performance will be overwritten onto
that track, erasing the previously recorded performance.
1
4
5
3
2
HP305_302_e.book 51 ページ ２０１０年１月５日 火曜日 午後１２時２分