Roland Juno-1 - Operation

9. Naming
the
Tone Colors
You can write a name (within 10
letters) to each
tone
coior, or rename it.
< OPERATION
>
(T)
Call
the tone
color which
you wish to
rename.
(2)
Push the Name Button
®.
The Display
©
will respond with:
(6)
Set the
Memory Protect Switch to the OFF
position.
(7)
By pushing
the appropriate Bank Selector
Button
(E)
and the Number Selector Button
<^
, assign the same
tone
color
you called
in the
step
®.
Example T
^^
Cursor
Tone Name
(D
Push
the Name
Button
®
as many
times
until
the cursor
comes under
the letter
to be changed.
The
cursor moves
one letter rightward
each time
the
Name
Button is pressed.
When the cursor
reaches the right end, it
goes back to the beginning.
(4)
Change the name by using
the a Dial
O
-
The available
letters for naming are
as follows.
The Display
®
will change to:
Example
T Renaming M-ll
While holding
the Write Button
®
down
a^
Tone Color
to be
renamed
Cursor
Push the Bank
Selector Button jTj
11
-HI--
11
Cursor
(Space)
f^VPhen
(5)
Repeat the steps
CD
®
as many times
as
necessary.
Push the
Number
Selector Sutton |Tj
New Name
Return the Memory Protect
Switch
®
to
the ON
position.
*
Taking the
operation (7) will
automatically
write
the
tone color
selected in the step
®.
So
if you
do not change
the tone color but only the
tone
name,
assign the same tone
color you called
in
the step
®.
30