Roland JUNO-D - Using the Rhythm Guide; Selecting Rhythm Patterns

36
Using the Rhythm Guide
The Rhythm Guide provides an easy way to produce full-fledged rhythm patterns
as easily as using a metronome.
The Rhythm Guide can be used only in Performance mode , which lets you perform
on the keyboard while using drum sounds simultaneously.
Selecting a rhythm pattern
fig.q06-22
1. Press [PERFORM] so it is lit and you are in Performance mode.
2. Press [RHYTHM GUIDE] so it is lit.
The rhythm pattern will begin playing.
3. With the display showing the pattern name, use VALUE [-]/[+] to select a
rhythm pattern.
4. Once again press [RHYTHM GUIDE] so it is unlit; the rhythm pattern will
stop.
To select a rhythm pattern without playing it
1. Press [PERFORM] so it is lit and you are in Performance mode.
2. Press [RHYTHM GUIDE] while holding down [SHIFT].
3. Use VALUE [-]/[+] to select a rhythm set.
4. Press [ENTER] to play back the rhythm pattern.
Performance mode (p. 55)
1
2, 4
3
If you want to change the
part that you will play
along with the rhythm
guide, press [PART
SELECT] so it is lit; then
use [1]–[9] to select the part
(category) that you want to
play from the keyboard.
JUNO-D_e.book 36 ページ ２００４年６月１１日 金曜日 午後１時２１分