Roland JV-880 - Master Tune; Output Mode

PARAMETER
FUNCTIONS
Some of the
parameters
explained
in this
section may not be
active,
depending
on settings in the
System
Common
parameters.
These
inactive
parameters are
not displayed
in the LCD.
For such
parameters, the
relevant
System
Common parameters are described at
the side of
the LCD
illustration.
Master
tune
S y
•=
t e
r-'i
Master t u
n e
=
4 4 .
e H
z
This parameter controls
the overall tuning (pitch) of
the JV-880.
The value
is expressed
as the
frequency of
the A4 key. The greater
the value,
the higher
the pitch.
Range:
427.4
—
452.6Hz
Output
mode
Out
t e
n
F' u t
p-j
I' d e
-
=
4
li
U T
This
parameter determines the
jacks from
which
the
sound will
be output.
Settings:
2 OUT/4 OUT
2
OUT
:
The stereo
(L/R) signal with
effects is output
through
the MAIN
OUTPUT
jacks.
4
OUT
:
Sounds without
effects are
output
through
both
the
MAIN
OUTPUT
and SUB
OUTPUT jacks. The
settings of the
Output Select
of each Patch
(See
P.
6-53) and
the
Performance
(See P.
7-1
5)
determine from
which
set of jacks,
MAIN or SUB,
the sound will
be
output.
20UT
„
j— Reverb
—
i
L
'
'
L^
MAIN
OUTPUT
Chorus
Reverb
L
_H
,
1
)—
m^
40UT
Output select
MAIN
OUTPUT
SUB OUTPUT
*
When
4 OUT is selected, the VOLUME
knob
only
controls
the level
of the MAIN OUTPUT
jacks.
The level
of the SUB OUTPUT jacks
is
fixed.