Roland JX-3P - Verify

If
your tape recorder
features the recording
level control,
set it so that
the Pilot tone
reads
higher than
VU.
14
ovu
*The
indicators
of the
Tone
Selector but-
tons
1 to 8
{1 to 16 in saving
Tone
Color
data)
will
flash
for a while
one after
another,
then
those
of
the
Bank
button
A
and the
Tone
Selector button
1
will light
up showing
that
the saving
is completed.
^ After
pressing
the TAPE
MEMORY
but-
ton
@),
you cannot
stop
saving in the
middle.
'You can
save
the tone
colors in a whole
Bank,
but
cannot save
a single
patch.
6
Stop the tape recorder..
B)
Verify
Sequencer
Data
Tone Color
Make
sure that
the built-in sequencer
is
not
working
and press
the TAPE
MEMORY
button (its Indicator
will light
up).
Set the tape
recorder so that
the tape will
start
from the very
beginning of the
data
{where the Pilot
tone is heard).
*lf
your tape
recorder features the
play
back level
control, set
it to medium.
Set the
tape recorder
to the playing mode
(PLAY).
If
you have
selected
a File Number
in sav-
ing,
select that
File Number.