Roland JX-3P - Page 15

15
Press the Tone
Selector
button 12.
-^h
Press the Tone Selector button 15.
L^
*The
indicators
of the
Tone Selector but-
tons 1 to
8
(1 to 16
in saving
Tone Color
data) wilt
flash for a
while one after
another, then the
indicators of the
Bank
button
A
and
the Tone
Selector button 1
will
light up, displaying
that verifying
Is
completed.
*lf
you wish to
stop verifying in the mid-
dle, press the TAPE MEMORY button
(|9)
(the indicator will go out}.
6
Stop the tape recorder.
If there
is an error,
the indicators of the
Tone Selector
buttons 11
to 16 will flash
for a while one
after another. If
so,
press
the TAPE
MEMORY button
to leave the
Tape Memory
mode, then repeat verify
procedure taking
care of
the following
points.
a)
Be sure to
press the Tone
Selector but-
tons
(12 or
15) While the Pilot tone is
still heard.
b)
Adjust the
playing back
level of the tape
recorder.
c)
Make sure
that the connections
are ail
made correctly.
If the error
is indicated the
very beginning
pf the
verify
procedure,
particularly take
care of
a).
If
the verify
procedure did not
complete even after 1
minutes,
b)
and
c)
are specially
important,
*if all the proradures
have been correctly
done, it is likely
that
there is something
wrong
with the tape.
•
If
the
error is again indicated
.....
Carefully repeat the save procedure.
*lf the
error
is
indicated
again and again
no
matter how many times you
try ...
•
Replace with a new tape.
•
Clean and demagnetize the head of the
tape recorder.
•
Use a
different tape
recorder and
repeat
the same procedure.
'Preserving the Data Tape
Please do
not keep
the data recorded
tape
in a
place of high temperature
or
humidi-
ty
or near a strongly magnetic unit such
as a spea
ker or
an
amplifier.