Roland JX-3P - Programmer PG-200

9.
Programmer
PG-200
The
following
table shows all
the elements
that
can be edited
in the JX-3P
as well
as
the functions
of the
Programmer PG-200.
The Sens knob
on
the JX-3P corresponds
to all the rotary
knobs
on the PG-200.
21
Raising or rotating
the knobs
toward ievel
10
will deepen the
effects. Also,
each ele-
ment to be edited is shown
by
the
Group
(A
or
B)
and number
(1
to
16) like
A-1,
A-5, etc.
DCO
(DigitaHy
Controlled
Oscillator)
DCO is the digitally
controlled oscillator
that controls
the
pitch and generates
the
waveforms
that
are the sound
source of the
synthesizers.
Owing
to its digitally
control
system, this
offers superior
pitch stability
compared to the VCO (Voltage
Controlled
Oscillator).
Programmer
Editing intheJX-3P
Range
Range
15'
f
4'
This is
to change
the pitch range of the
DCO in exact one
octave steps from
4'
to
16'
(4*,
8',
16'}.
8'
is
standard.
A- 1
A-5
Bank button (A to C}
BS M.
16'
8' 4'
Waveform
Waveform
-^
V
nj
This is to choose the
output
waveform
of the DCO.
[NOTE
1]
A-2
A-6
Bank button {A
to
C}
aa mw
-v
ru ru
(Noise)
Frequency Modulation
{LFO switch)
Freq Mod
LFO
On
Oft
Frequency
Modulation
(ENV switch)
If
this is
set to ON, the
LFO
controls
the
frequency
(pitch)
of
the DCO,
therefore,
a
vibrato effect can be ob-
tained.
[NOTE
2]
A-3
A- 10
Bank button (Aor
B)
Off
On
Freq Mod
ENV
On
Oil
M
If this
is set
to ON, the ENV signal
controls the
frequency
(pitch) of the
DCO.
A-4
A-11