5.
Performance
Control
Section
LFOTr>fl
©-
PITCH BENDER
©PITCH
BENDER
This allows you to change the
pitch of the
DCO.
By
bending this
in either direction,
you
can add a
special
expression
to your
performance. This function,
however,
has
no effect
on the sequencer
sounds.
(2)
Bend
Range switch
This sets the
maximum
effect
of the
Bender.
Wide
Maximum
effect is
perfect
5th
higher
or
lower.
Mid
Maximum
effect is
major
3rd higher
or lower.
*
Narrow Maximum effect
is major
2nd higher
or lower.
(3)
LFO
Trigger button
Hold
this button
down
to
obtain
a
vibrato
effect, and release
it to stop the
effect.
This
can be applied to
the sequencer
play-
ing.
*
There are
some patches
in which you
can-
not
obtain a
vibrato
effect
by
pressing
this
button.
@-
m
.n.
ChonjE lAulB
Key
Hold TranspoB
(4)Brj!liance
knob
A
brighter
tone color will be obtained by
raising
this
knob, and mellower tone color
by
lowering
It.
(5)
Volume
knob
d)
Chorus
button
Press
this button
to
turn
the chorus effect
on (the
indicator lights up), and
press it
again to turn it off.
(7)
Mute
button
if you
press this button, the volume
of
the
lower two octaves from the split
mark
(blank on the red line) on the Front Panel
will
be decreased. The chord
will
sound
low, and the melody will be emphasized.
Each time
you
press this button,
the func-
tion is turned on
or off.
To Next Page
Loading...
