4
Functionality Added in M-480 Ver. 1.6
You can check or alter the wireless settings using the steps below.
1. Call up the REMOTE popup (WIRELESS LAN tab)
Press [SYSTEM] > [F4 (REMOTE)] > [F6 (WIRELESS LAN)]. You can call up the REMOTE popup (WIRELESS LAN tab).
* You can only use the wireless LAN function when the “Enable Wireless LAN” is checked.
fig.call-wireless-LAN-tab.eps
2. Call up the WIRELESS LAN SETUP popup
Move the cursor to the SETUP button and press [ENTER] to call up the WIRELESS LAN SETUP popup.
fig.wireles-LAN-setup.eps
About the Status Display
• CONNECTED
The M-480 is connected to the wireless LAN access point. This part also shows the ID (name) of the access point.
• NOT CONNECTED
Although the wireless USB adaptor is connected, the M-480 is not connected to the wireless LAN access point.
• NOT AVAILABLE
The wireless USB adaptor is not connected.
• AD-HOC MODE
The unit is in Ad-Hoc mode. Refer to “Connecting in Ad-Hoc Mode” (p. 7).
• DISABLE
The wireless LAN function is disabled. The “Enable Wireless LAN” is not checked.
Wireless LAN Function Settings
To Next Page
Loading...
