Roland MDX-50 - User Manual

Thank you very much for purchasing this product.
 To ensure correct and safe usage with a full understanding of this product's performance, be sure to read through this
document completely and store it in a safe location.
 Unauthorized copying or transferal, in whole or in part, of this document is prohibited.
 The contents of this document and the specifications of this product are subject to change without notice.
 This product and this document have been prepared and tested as much as possible. If you find any misprints or errors,
please inform us.
 Roland DG Corporation assumes no responsibility for any direct or indirect loss or damage that may occur through use
of this product, regardless of any failure to perform on the part of this product.
 Roland DG Corporation assumes no responsibility for any direct or indirect loss or damage that may occur with respect
to any article made using this product.
User's Manual

Summary

Built-in Panel Operation Guide

Built-in Panel Screen and Functions

Overview of the built-in panel screen, its functions, and operational keys for machine control.

Cutting Process Guide

Safety and Status Monitoring

Procedures for emergency stops, cover safety, and interpreting machine status lights during cutting.

Origin Setting and Data Output

Steps for setting XY/Z origins and sending cutting data to the machine for execution.

Troubleshooting Common Issues

Machine, VPanel, and Connectivity Problems

Diagnosing issues with power, VPanel, drivers, and machine connectivity.

Cutting Quality and Origin Errors

Error Message Reference

A guide to understanding and resolving specific error codes displayed by the machine.

Roland MDX-50 Specifications

General

Model	MDX-50
Category	Lathe
Positioning Accuracy	±0.01 mm
XYZ Drive method	Ball screw
Software resolution	0.001 mm
Mechanical resolution	0.001 mm
Interface	USB
Repeatability	±0.005 mm
Control Software	SRP Player
Compatible Materials	Wood
Power Requirements	AC 100-240V, 50/60Hz