7
Jan. 2014 ME-80
Exploded View (All) Parts List
Disassembly Procedure
1.
Remove screws
d
(11) in
View 2
(
Plane View (1)
(p. 8)).
2.
Lift the Bottom Cover slightly and detach the wiring (1) connecting the
Main Board and the Battery Case Set.
Important Notes on
Assembly
On the ME-80, not all potentiometers use potentiometer nuts.
Nuts are used only at the locations shown below.
When reassembling the unit, carry out assembly with reference to the
figure below.
fig.kumitate.eps
No.
Part Code Part Name Description Q’ty
1 03344934 R-KNOB (75D522N0R0) 30
2 ******** NUT attached to VR 13
3 ******** NUT attached to VR 7
4 22360712 CORD HOOK 236-712 1
5 5100018071 POWER SW ESCUTCHEON G2207430R1 1
6 12499175 BUTTON JSPUE0011A 1
7 5100003918 JACK NUT M9X12X2 NI RTC(H5039510R0) 3
8 5100003926 PLAIN WASHER 9X13.5X0.5T NI(H5039158R0) 3
9 5100037540 TOP COVER 1
10 ******** NUT 1
11 ******** WASHER 1
5100037426 PANEL SHEET ASSY 1
* This unit includes the following parts.
12 ******** EXP BOARD 1
13 ******** PANEL BOARD 1
14 ******** JACK BOARD 1
15 5100037421 MAIN BOARD ASSY 1
16 5100002398 7 SEG COVER (G2567172R0) 1
17 5100037543 KEYTOP UNIT 1
18 5100021018 PWB SPACER LBC-08-N2W 2
19 5100037541 BOTTOM COVER 1
20 5100038986 BATTERY CASE SET 1
21 04560878 BATTERY COVER RTC #G2027602R0 1
22 03344923 FOOT H=5 (G2357120R0) 5
23 5100037403 FLAT CABLE SML2CD-28X80-BDX6(BL)-P1.0-S4 1
24 40122645 NITTO FILAMENT TAPE #3883 W19MM 50M 60P (CM) -
25 03561356 SHAFT STAY STAY 1
To Next Page
Loading...
