Roland R-07

Getting Ready
11
4. Use [ ]/[ ] to choose “Yes,”
and then press [ ].
The display indicates “Pairing...”, and
this unit waits for a response from the
Bluetooth device.
When pairing succeeds, the display indicates “Completed.” and
sound can be output from the Bluetooth device.
Connecting an already-paired Bluetooth device
1. Press [MENU] to access the “Menu” screen, use [ ]/[ ]
to select “Bluetooth,” and press [ ].
2. Use [
]/[ ] to select “Connect Audio” and press [ ].
3. Select the playback device that
you want to use, and press [
].
4. Use [
]/[ ] to choose “Yes,” and then press [ ].
The display indicates “Connecting...”, and this unit waits for a
response from the Bluetooth device.
When the connection succeeds, the display indicates “Completed.”
and sound can be output from the Bluetooth device.
4. Using Headphones
The R-07 has a built-in speaker. You can listen to the playback
through this speaker, or you can connect headphones for listening.
You can also connect Bluetooth headphones to the R-07 and listen
wirelessly to the playback.
* To prevent malfunction and equipment failure, always turn
down the volume, and turn o all the units before making any
connections.
Connecting Bluetooth® Headphones
Supported codecs: SBC, Qualcomm® aptX™ audio,
Qualcomm®aptX™ Low Latency audio
Registering a Bluetooth device (Pairing)
“Pairing” is the procedure by which the mobile device that you want
to use is registered on this unit (the two devices recognize each
other).
Once a mobile device has been paired with this unit, there is no
need to perform pairing again. After the R-07 starts, it searches for
the previously-connected device, and connects automatically.
1. Place the Bluetooth device that you want to connect
near the R-07, power-on the device, and put it in pairing
mode.
For details, refer to the owner’s manual of your Bluetooth device.
2. Press [MENU] to access the “Menu” screen, use [ ]/[ ]
to select “Bluetooth,” and press [ ].
3. Use [ ]/[ ] to select “Pairing Audio” and press [
].