Roland RML-1 User Manual

RML-1 PROGRAMING GUIDELINE
- 12 -
performed.
^ (Call mode 2 -- Command for calling a mode 2 command)
<Format>
^ [mode 2 command] [parameter]...[parameter] [terminator(;)]
<Parameter Range>
This depends on the mode 2 command set.
<Description>
This calls a mode 2 command from mode 1.
For parameters, refer to the description for the called mode 2 command.
When only "^" is given, this instruction set does not end until a mode 2
command is executed or until a numeral, sign, or other such data that
results in a mode 2 error is encountered.
<Errors>
This command itself does not generate any errors.
Generation of an error by the mode 2 command is possible.
Also, if the called mode 2 command does not exist, then in principle error 2
for mode 2 is generated at that time.
H (Home -- Origin-movement command)
<Format>
H [terminator]
<Description>
This moves the tool to the uppermost position, then moves to the
workpiece-coordinate origin point on the XY plane. It then stops the
spindle motor.
If the workpiece-coordinate origin point is outside the cutting range, then
this moves, for example, to the clip location.
-> Command errors are cleared.
-> After the operation, the settings for tool-up, absolute-
coordinate mode, and coordinate values are reset.
The present position of the tool is the same as the position in the
workpiece coordinate system.
<Errors>
No error is generated.
<Other Matters>

Roland RML-1 Specifications

General

Brand	Roland
Model	RML-1
Category	Power Tool
Language	English