Roland RP30 - Page 7

Setup
- If necessary, spread out a blanket or similar material to prevent the stand or floor from being scratched during assembly.
- Be careful not to pinch the pedal cable during assembly.
- When handling the piano, firmly grasp it. Be careful, so you do not get your fingers pinched.
A. Put the “Pedal box” between the “Left and Right leg components.”
Use “Screws M6 x 40 (4 pcs)” to stablize the “Left and Right leg
components” onto to the pedal assembly, then cover with “Plastic
caps (4 pcs),” as shown in the picture.
B. Use “Screws 4 x 15BA (8 pcs)” to affix the back board to the stands,
as shown in the picture.
C. Put the “Piano body” on the top of the assembly finished
in part B, then affix it with “Hand screws (4 pcs),” as
shown in the picture.
07
Screws M6 x 40 (4 pcs)
Plastic cap (4 pcs)
Screws 4 x 15BA (8 pcs)
Hand Screws (4 pcs)
Please don’t get your fingers
pinched.
C
M
Y
CM
MY
CY
CMY
K
Roland_RP30_manual_G02_20170905.pdf 7 17/9/5 17:08