Roland SP-404SX

17
Deutsch Français Italiano Español Português NederlandsEnglish
Connecting a Mic
To use a mic, connect it to the MIC IN jack, then press the [MIC] button so it’s lit.
MIC IN jack
Press the [MIC] button so it’s lit.
MEMO
If you’re not using a mic, leave this button
unlit.
Using the built-in mic
If you want to use the built-in mic, don’t
connect anything to the MIC IN jack.
The built-in mic won’t operate if a mic is
connected to the MIC IN jack.
Howling could be produced depending on the location of
mics relative to speakers. This can be remedied by:
1. Changing the orientation of the mic(s).
2. Relocating mic(s) at a greater distance from speakers.
3. Lowering volume levels.
Importing WAVE  les from your computer
By using the included “SP-404SX Wave Converter” software, WAV or AIFF  les from your computer can be written to an SD
card and assigned to the pads of the SP-404SX.
For details, refer to “Importing Wave Files from Your Computer” (p. 22).
Use the “SP-404SX Wave Converter” software on
your computer to copy the data to SD card
Load the data from SD
card into the SP-404SX
Card reader (sold separately)
WAV
AIFF