Roland V-Mixer VM-3100 - Page 102

VM-3100 List of Algoriyhms
DYNAMICS PROCESSOR A/B
These parameters are the same as those in Algorithm 14
(STEREO DYNAMICS PROCCESSOR) (p.25).
Threshold [Thre] (Threshold Level)-60 — 0dB
Attack [Atk] (Attack Time)0 — 100
Release [Rele] (Release Time)0 — 100
Ratio [Ratio] (Compression Ratio)1.5:1,.2:1, 4:1, 100:1
Out Level [OutLv]-60 — +12dB
Sens [Sens] (Sensitivity)0 — 100
Frequency [Freq]1.0 — 10.0 kHz
Mix Level [MixLv]0 — 100
Out Level [OutLvJ0 — 100
Low Type [LType]SHELV, PEAK
Low Freq [LFreq]20 — 2000 Hz
Low Gain (LGain]-12 — +12 dB
Low Q [LQ] 0.3 - 10.0
Mid Freq [MFreq]200 — 8000 Hz
Mid Gain (MGain]-12 - +12 dB
Mid Q [MQ] 0.3- 10.0
High Type [HType]SHELV, PEAK
High Freq [HFreq]1.4 — 20.0 kHz
High Gain [HGain]-12 - +12 dB
High Q [HQ] 0.3 - 10.0
Out Level [OutLv]-60 — +12 dB
Threshold [Thre] (Threshold Level)0 - 100
Release [Rele] (Release Time)0 — 100
16 PARAMETRIC EQ
This is four-band parametric equalizer can be used as either
two monaural equalizers or a single stereo equalizer.
Parametric
Equalizer
A —>
Lat
et
LINK
These parameters are the same as those in the LINK in
Algorithm 12 (Mic Simulator) (p.22).
Link Sw [LinkJOFF, ON
PARAMETRIC EQ A/B
This is a four-band parametric equalizer.
In Level [In Lv] (Input Level)-60 - +12 dB
This adjusts the level before the signal passes through the
equalizer.
Low Type [LType]SHELV, PEAK
This switches the Low EQ curve characteristics (peaking-
type/shelving-type).
Low Freq [LFreq] (Low Frequency)
20 - 2000 Hz
This adjusts the Low EQ center frequency.
Low Gain [LGain]-12 - 12 dB
This sets the gain (boost or cut) of the equalizer’s low range.
Low Q [LQ]0.3 - 10.0
This sets the “Q”, or frequency range over which the sounds
passing through the Low EQ are boost or cut. The higher the
value set, the narrower the range.
LoMid Freq [LMFrq ] (Low-Middle Frequency)
200 - 8000 Hz
This adjusts the Low-Mid EQ center frequency.
LoMid Gain [LM-G ] (Low-Middle Gain)
-12- 12 dB
This sets the gain (boost or cut) of the equalizer’s Low-Mid
range.
LoMid Q [LMQ] (Low Middle Q)0.3 - 10.0
This sets the “Q”, or frequency range over which the sounds
passing through the Low-Mid EQ are boost or cut. The
higher the value set, the narrower the range.
HiMid Freq [HMFrq] (High-Middle Frequency)
200 - 8000 Hz
This adjusts the High-Mid EQ center frequency.
HiMid Gain [HM-G ] (High-Middle Gain)
-12- +12 dB
This sets the gain (boost or cut) of the equalizer’s High-Mid
range.
HiMid Q [HMQ] (Hi-Middle Q)0.3 - 10.0
This sets the “Q”, or frequency range over which the sounds
passing through the High-Mid EQ are boost or cut. The
higher the value set, the narrower the range.
High Type [HType]SHELV, PEAK
This switches the High EQ curve characteristics (peaking-
type/shelving-type).
High Freq [HFreq] (High Frequency)
1.4 = 20.0 kHz
This adjusts the High EQ center frequency.
High Gain [HGain]-12 - +12 dB
This sets the gain (boost or cut) of the equalizer’s high range.
High @ [HQ]0.3 - 10.0
This sets the “Q", or frequency range over which the sounds
passing through the High EQ are boost or cut. The higher the
26