Roland V-Mixer VM-3100 - Page 44

44
CO Co
Confirm the sequencer’s functions.
First, confirm that your sequencer can receive MIDI messages to allow
another device to start and stop playback of the sequencer.
When you have confirmed that the sequencer can do this, check which
other MIDI messages the sequencer can receive.
After referring to the sequencer owner’s manual, now select the MIDI
messages to be used to start and stop playback of the sequencer.
Make the settings as shown below.
¢ MIDI message for starting playback of the sequencer Note On
message for Note Number CO
¢ MIDI message for stopping playback of the sequencer Note Off
message for Note Number DO
Set the VM-3100.
Next, set the VM-3100 so that the above MIDI messages are sent when
the [PLAY] and [STOP] buttons are pressed.
Press the [SYSTEM] button, then press the [F1-F4 ON/OFF] button.
aa
SVSTEM PREF
MasterCik
Phantom
INTERNAL
[s) OFF
PREF BMIDT § EULER INIT
The Function screen is displayed; press the F2 (MIDI) button, then press
the [F1-F4 ON/OFF] button.
om oe
| A
The Function screen shown below is displayed; press the F1 (USER1)
button.
MEMD
For detailed information
about the sequencer, read
the owner's manual for the
sequencer you.are using.
n>
Most sequencers handle
Note On and Off messages
and Control Change
messages. Furthermore,
with many sequencers, you
have further freedom in
setting these MIDI
messages.