Roland V-Mixer VM-3100 - Page 47

Next, select the MIDI channel number for the MIDI messages.
Press the CURSOR button 4 to select “(Control)Ch,” and rotate the
[VALUE] dial to select “16.”
“A
SYSTEM
MIDI
)
pp
Control
Tare
enol
+
C.C.
Ture
Press the CURSOR button (4 to select “C.C. Type,” and
rotate the [VALUE] dial to select “MONO.”
SYSTEM MIDI
Contral Tyre
Ch
7 C.c. Tyre
This enables the information from each fader to be sent as Control
Change messages over one MIDI channel.
Press the CURSOR button -4y to select “Local,” and rotate the
[VALUE] dial to select “OFF.”
SYSTEM MIDI
bevicelD
With this set to “OFF,” the data for the fader movements is output from
the MIDI OUT/THRU connector instead of adjusting channel levels of
the mixer.
Press the [LEVEL METER] button to bring up the Level Meter screen.
" =
METER
PSt]i 2234S HE TE9MHNI2 L-R
Set up the sequencer.
Set up the sequencer to enable recording of the VM-3100's fader
movements as MIDI messages. (as described below)
¢ Prepare a track to record the data for switching the VM-3100's
SCENE MEMORY.
* Assign this prepared track to an unused MIDI channel.
MEM
Select “Local Off” when
recording fadermovements
to a sequencer.
For detailed information
about the sequencer, read’...
the owner's manual forthe.
sequencer you are using...
se
ge
Sip.
Be ees
55
3g
7 fo
Line
pea oa
te peck
wit
ae}
ne
SS:
-Whatis: the VM:3100 Series
¥-Mixing Station?:
Part Names
Trying Out the
wy
a
Q
BS
i
QP
i
ss
<