Roland V-Mixer VM-3100 - Page 65

Error Message List
@ With Operational Commands
- Are You SURE?
Is it all right to execute this operation? (When altering
data)
- Delete SURE?
Is it all right to delete? (When deleting data)
- Processing..
Processing in progress. Please wait.
- Processing..KEEP POWER ON!
Writing to internal memory in progress. Absolutely
do not turn off the power.
- Completed.
Processing is completed.
@ Restoring Routing Settings
(IN/OUT/EFFECT Routings Settings screen)
- Revert Routing?(YES/NO)
Do you want to restore the routings settings to their
previous conditions?
@ Switching Effect Patches and
Routing Sets
(Effect Knob screen/ Routing Selections screen)
- Change?(YES/NO)
Do you want to switch the indicated effects patch or
routing set?
@ Locking Channels in Stereo Link
(Pan screen)
- LINK CH**/**Are You Sure?
Do you want to put Channels ** and ** in “Stereo
Link” status?
- UNLINK CH**/**Are You Sure?
Do you want to release Channels ** and ** from
“Stereo Link” status?
@ Locking the Compressors in
Stereo Link
(Compressor Curve screen)
- LINK COMP1/2 Are You Sure?
Do you want to use the two monaural compressors as
a single stereo compressor?
- UNLINK CMP1/2 Are You Sure?
Do you want to use the single stereo compressor as
two monaural compressors?
@ Setting the Master Clock
- DIGITAL IN Checking..
Checking the signal being input to DIGITAL IN
connectors A or B.
- DIGITAL IN Locked!
The signal being input properly to DIGITAL IN
connectors A or B.
- DIGITAL IN Unlock!(TemporaryINT.)
The signal to DIGITAL IN connectors A or B is not
being input properly (switching to analog input until
the correct signals are input through the DIGITAL IN
connector).
- RMDBII Checking..
Checking the signal being input to RMDB II
connector.
- RMDBII Locked!
The signal being input properly to the RMDB II
connector.
- DIGITAL IN Unlock!(Temporary INT.)
The signal to the RMDB I] connector is not being
input properly (switching to analog input until the
correct signals are input through the RMDB II
connector).
- Wrong Sample Rate!(TemporaryINT.)
The sample rate for the signal input from the
DIGITAL IN A or B connectors or from the RMDB II
connector is incorrect (switching to analog input until
the sample rate for the signal input from the DIGITAL
IN A or B connectors or from the RMDB II connector
is correct).
m SCENE MEMORY Operations
- Changing SCENE..
Calling up SCENE MEMORY.
- Clearing SCENE..KEEP POWER ON!
Clearing SCENE MEMORY.
- Writing SCENE..KEEP POWER ON!
Writing SCENE MEMORY. Do not turn off the power.
@ Bulk Dump/Receive Operations
(System Bulk Dump/Receive screen)
- Now Sending..
Sending of bulk data is in progress.
- Waiting..
Waiting to receive bulk data.
- Now Receiving..
Reception of bulk data is in progress.
@ MIDI Reception
- MIDI Rx Error.(WrongFormat.)
An incorrect MIDI message was received (the
message is disregarded).
- MIDI Rx Error.(AddressError.)
The System Exclusive message address data or data
size is incorrect (the message is disregarded).
65
“USING THE UNIT SAFELY
IMPORTANT NOTES ett.
What is the VM-4190 Serigs °
V-Mixing Station?
Trying Out the VM-3100 Part Names
Digital Mixer Workbook