Roland V-Mixer VM-3100 - Page 91

VM-3100 List of Algoriyhms
Rate [Rate]O - 100
This sets the chorus modulation cycle time.
FX Level [EffLvjO - 100
This adjusts the chorus volume level.
Dry Level [DryLv]O - 100
This adjusts the volume level of the direct sound.
04 GUITAR MULTI 1
‘This is a multi-effect for guitars.
Guitar Amp
Simulator
Compressor Auto Wah Drive
Suppressor Delay Flanfer
COMPRESSOR
This effect compresses the level of the signal by reducing the
level of strong input signals and boosting low-level signals.
Attack [Atk] (Attack Time)O - 100
This adjusts the attack strength when the sound is input.
Level [Level] (Output Level)O - 100
This adjusts the Compressor volume level.
Sustain [Sus] (Sustain Time)O - 100
This adjusts the length of time that the compressor continues
to raise and hold the level of weak input.
Tone [Tone]O - 100
This adjusts the compressor tone.
AUTO/TOUCH WAH
Wah is an effect created by the periodic change in a filter's
frequency characteristics, giving a particular kind of tone
change. You can get the wah effect by changing the volume
of the input sound or by using cyclical time-based changes.
Type [Type] (Filter Type)LPF, BPF
This selects the type of filter used to make the wah.
This selects either the BPF (band pass filter) or LPF (low pass
filter).
When set to BPF, the wah effect occurs within a narrow
frequency range; setting this to LPF produces the wah effect
over a wide range of frequencies.
Frequency [Freq] (Cutoff Freqency)O — 100
This sets the reference frequency for the wah effect (the
frequency at which the wah starts).
Peak [Peak]O - 100
This sets the amount of wah effect near the reference
frequency. The range narrows as the value increases; lower
the value to get the wah effect over a wider range.
Polarity [Pol.]UP, DOWN
When the wah effect is added through changes in the source
sound volume, this setting is for selecting whether the effect
is to be added to the high frequencies (UP) or lower
frequencies (DOWN).
Trig.Sens [Sens]O - 100
Sets the sensitivity level when wah is added through changes
in the source sound volume. The wah effect is added at lower
volumes as the volume increaces.
LFO Depth [Depth]0 - 100
This sets the depth of the wah sound when the effect changes
cyclically. Set this to 0 when changes in the effect are not
based on time cycles.
LFO Rate [Rate]0 - 100
This adjusts the cycle time when the wah effect changes
cyclically.
DRIVER
This effect adds distortion, “spreading” the sound.
Type [Type]OD, DS, METAL
This selects the effect type.
METAL
This distorts the sound most.
DS
This is what most consider the typical distortion effect.
oD
This provides the mildest distortion of the three settings.
Gain [Gain]O - 100
This sets the amount of distortion.
Out Level [OutLv]O - 100
This sets the volume of the effect sound.
OD/DS Tone [Tone]0 - 100
This adjusts the tone character. Setting becomes valid when
TYPE is DS or OD.
METAL HiG [HGain] (High Gain)O - 100
This sets the gain of the high range. Setting becomes valid
when TYPE is METAL.
LTE
EEE
MIR
NENTS
ST
RE
ARR
aE
ES
EL
I
RS
AOE
ET
SN
RATE
15