Roland V-Mixer VM-3100 - Page 97

VM-3100 List of Algoriyhms
Notice on Package with RSS
RSS is an effect that gives the sound device three-
dimensional sound with an ordinary stereo system.
Monitoring environment is critical in exhibiting the RSS
effect to the fullest extent. We recommend that packaging for
products containing songs that use the RSS patch carry the
following description at the time of sale.
Ay For Stereo Speakers
This sound is made to be played specifically through speakers.
The proper effect cannot be obtained if listened to through headphor
Less reflections from the wall
or floor are better.
it a hard wail is close to it,
draw a curtain.
‘Ds
24 to 30 deg.
Speakers should be pace
as far away as possible from
the wall or floor.
ee
é
DELAY RSS
This single-input delay adds the RSS effect for widened
spatial characteristics.
Time [Time]1 -— 1200 msec
This sets the elapsed time between the source sound and the
delay sound (the delay time) in millisecond units. The
settings value is limited to the range allowed by the left-right
shift and RSS shift settings.
RSS Shift [RsSft] (RSS Time Shift)
-1199 - 1199 msec
The further increases the delay time only of sounds
processed through RSS before the sounds are played. The
settings value is limited to the range allowed by the delay
time and left-right shift settings.
L-R Shift [LRSft] (L-R Time Shift)
L1199 - R1199 msec
This shifts the location from where the sound appears to
originate by increasing the delay sound only on the left or the
right. The settings value is limited to the range allowed by
the delay time and left-right shift settings.
(i a ar ae
Original sound
o—
_~
ra
|
(Delay)
Time
Th
—-A
RSS Shift L-R Shift
Feedback [FB Lv] (Feedback Level)O - 100
This sets the delay sound repeat time. When set to 0, the
delayed sound is played only once.
FX Level [EffLvJO - 100
MonobDly [Mono] (Monaural Delay Level)
0-100
RSS Dly [RSS] (RSS Delay Level) 0 - 100
This sets the volume of the delay sound. Set levels for the
monaural delay and RSS delay sounds individually, and then
adjust the total level of the overall effect. You can better
interpret the RSS effect by setting the monaural delay level to
0. However, with the L-R shift set to 0 (no shift), the RSS
effect may be difficult to hear.
Dry Level [DryLv] 0 - 100
This sets the volume of the source sound. Set this toO when
using the send/return method. Increase the value when
using the insert method to mix the source sound into the
output.
LoDampFreq [LDFrq] (Low Damp Frequency)
50 - 4000 Hz
The Low Damp effect rapidly dampens the low frequency
range of the delayed sound, resulting in a cleaner delay
effect. This sets the upper frequency limiting the range to be
dampened.
LoDampGain [LD-G] (Low Damp Gain)
-36 - 0 dB
This sets the amount of the Low Damp effect.
21