Roland VG-99 - Page 3

Roland VG-99 Training Guide
Page 3
2. QUICK DEMO
The Roland Quick Demo is a way to get a customer interested in a product in
less than 60 seconds.
Before You Start
STEP ONE-Connect the VG-99
If you have a PA or studio playback system
1. Connect the Left and Right MAIN or SUB OUTPUTS of the VG-99 to two
channels of the PA.
2. Set the PA’s EQ controls for a flat response.
3. Press GLOBAL.
4. Press the F4 button or turn the F4 knob to select LINE/PHONES.
5. Press EXIT.
If you only have a guitar amp:
1. Connect the MONO MAIN OUTPUT of the VG-99 to a clean channel of
the amp.
2. Set the EQ of the amp to a flat response.
3. Press GLOBAL.
4. Press the F4 button or turn the F4 knob to select COMBO AMP.
5. Press EXIT.
If you are using headphones:
1. Press GLOBAL.
2. Press the F4 button or turn the F4 knob to select LINE/PHONES.
3. Press EXIT.
STEP TWO: Set the Sensitivity
This is the most important procedure of the VG-99. Setting sensitivity adjusts
how the VG-99 responds to how you play; it’s much like getting a level when
recording.
1. Connect a divided pickup equipped guitar (Fender Roland Ready Strat,
Brian Moore i-guitar, Godin with Synth Access, or other) to the VG-99 via
the included 13-pin cable.
2. Press SYSTEM.