Roland VR-700 - Restoring the Factory Settings (Factory Reset)

26
Getting Ready
When you execute the Factory Reset operation, all Favorite settings
in the VR-700 and the values of the system parameters that can be
edited in Function mode will all be returned to their factory-set
condition.
If you want to keep the Favorite settings that are stored in the
VR-700 and the values of the system parameters, back them up
to USB memory as described in “Backing up Favorites to USB
Memory” (p. 48).
1.
Press the [FUNCTION/ENTER] button.
The VR-700 will enter Function mode, and the display will indicate
.
2.
Use the [–] button or [+] button to make the display
indicate
.
3.
Press the [STRINGS] button.
The display will indicate
.
4.
Press the [FUNCTION/ENTER] button.
The display will indicate
.
5. To execute the Factory Reset, press the [FUNCTION/
ENTER] button.
The display will indicate
while the Factory Reset is being
executed.
Never turn off the VR-700’s power while the Factory Reset is
being executed.
* If you decide not to execute the Factory Reset, press the [DISPLAY/
EXIT] button.
6.
When the Factory Reset is completed, the display will
indicates
.
Turn the VR-700’s power off, then on again.
Restoring the Factory Settings
(Factory Reset)
VR-700_e.book 26 ページ ２００９年１１月１８日 水曜日 午前９時２４分