Roland VS-2000 - Page 30

30
Algorithm List
Multi Tap Delay
This is a Delay feature that can set 10 delay sounds separately.
fig.08-45
Parameter (full name) Setting Function
MTD (Multi-Tap Delay): Issues 10 delay sounds separately.
Time Ch1 – Ch10 (Delay Time 1 – 10) 0–1200 ms Sets the time from the direct sound until when the delay sound for channels 1–10 is heard.
Level Ch1 – Ch10 (Delay Level 1 – 10) 0–100 Sets the volumes of delay sounds for channels 1–10.
Pan Ch1 – Ch10 (Pan 1 – 10) L63–R63 Sets the pan of the delay sounds for channels 1–10.
FBTim (Feedback Delay Time) 0–1200 ms Sets the repetition frequency for feedback.
FBLvl (Feedback Level) -100–100 Sets the amount of the delay sound should be returned to the delay input.
FX Lvl (Effect Level). -100–100 Sets the volume of the delay sound.
DirLvl (Direct Level) -100–100 Sets the volume of the direct sound.
EQ (Equalizer)
Sw (Switch) On, Off Turns the equalizer on or off.
Low Gain (Low Gain) -12– +12 dB Sets the boost/cut amount in the low frequency band.
Low Freq (Low Frequency) 20 - 2000 Hz Sets the center frequency in the low frequency band.
Low Q 0.3–10.0 Sets the width of the area around the low frequency that will be affected by the gain settings. *1
Low Type Shlv, Peak Sets the type of the low frequency band equalizer (Shlving type or peaking type).
Mid Gain (Middle Gain) -12– +12 dB Sets the boost/cut amount in the middle frequency band.
Mid Freq (Middle Frequency) 200–8000 Hz Sets the center frequency in the middle frequency band.
Mid Q (Middle Q) 0.3–10.0 Sets the width of the area around the middle frequency that will be affected by the gain settings.
High Gain -12– +12 dB Sets the boost/cut amount in the High frequency band.
High Freq (High Frequency) 1.4–20.0 kHz Sets the center frequency in the High frequency band.
High Q 0.3–10.0 Sets the width of the area around the High frequency that will be affected by the gain settings. *1
Hi Type (High Type) Shlv, Peak Sets the type of the High frequency band equalizer (Shlving type or peaking type).
Level (Output Level) 0–100 Sets the volume after passing through the equalizer.
*1: If Low Type (Lo Type) or High Type (Hi Type) is set to “Shlv (Shlving Type),” the setting for Lo Q or High Q is invalid.
Input R
Output R
Multi Tap Delay
3BAND EQ
3BAND EQ
Pan 1
Pan 2
Pan 10
Feedback Level
Direct Level
Direct Level
Input L
Output L
VS-2000_e.book 30 ページ ２００５年１２月１２日 月曜日 午後４時５４分