Roland VS-2000 - Page 29

29
Algorithm List
Tape Echo 201
Models the tape echo section of the Roland RE-201 Space Echo. Capable of reproducing very subtle behavior at the measuring
instrument level as well as adding subtle changes in pitch due to deterioration of the tape or inconsistency in tape rotation
fig.08-71
Parameter (full name) Setting Function
Echo (Tape Echo 201): Models the tape echo section of the Roland RE-201 Space Echo.
Sw (Switch) On, Off Turns the tape echo on or off.
Mode (Mode Selector) 1–7 Selects a combination of the three replay heads.
Repeat Rate (Repeat Rate) 0–100 Sets the tape speed.
Intnsty (Intensity) 0–100 Sets the number of repeated the delay sound.
Tone Bass (Tone Bass) -100– +100 Sets the low frequency band tone of the tape echo sound.
Tone Treble (Tone Treble) -100– +100 Sets the High frequency band tone of Tape Echo sound.
Pan HeadS (Pan Head S) L63–R63 Sets the pan settings for the short delay play back head.
Pan HeadM (Pan Head M) L63–R63 Sets the pan settings for the middle delay play back head.
Pan HeadL (Pan Head L) L63–R63 Sets the pan settings for the long delay play back head.
Tape Dist (Tape Distortion) 0–100 Adds tape-specific distortion.
WowFluter Rate (Wah-Flutter Rate) 0–100 Sets the fluttering rate of pitch due to deterioration of the tape or inconsistency in the rotation.
WowFlutter Depth (Wah-Flutter Depth) 0–100 Sets the fluttering depth of pitch due to deterioration of the tape or inconsistency in the rotation.
FX Lvl (Effect Level). 0–100 Sets the volume of the tape echo sound.
DirLvl(Direct Level) 0–100 Sets the volume of the direct sound.
TapeEcho201
Input L
Input R
Output L
Output R
About replay head
RE-201 is equipped with three heads for creating sounds with different delay times (short, middle and long delay sounds).
A desired combination of heads for use can be selected with Mode Selector (Mode).
In addition, separate panning features for the three replay heads not included in RE-201 are added.
VS-2000_e.book 29 ページ ２００５年１２月１２日 月曜日 午後４時５４分