Roland VS-2000 - Page 28

28
Algorithm List
Delay RSS
The right-side, left-side and center Delay sounds can be set separately. As RSS (p. 37) is connected to both the right and left outputs,
the sound image of the sound from the left-side channel is localized at 90˚ to the left and that of the sound from the right-side
channel at 90˚ to the right. The center Delay output can receive the Feedback effect.
fig.08-20
Parameter (full name) Setting Function
DlyRSS (Delay RSS): Gives three-dimensional location to Delay sounds.
Time (Delay Time) 0–1200 ms Sets the time from direct sound until when the left and right delay sound is heard.
shift (Delay shift) L1200–0–R1200 ms Sets the balance of the right and left delay times.
C.Time (Center Delay Time) 0–1200 ms Sets the time from direct sound until when the center delay sound is heard.
RSS Lvl (RSS Level) 0–100 Sets the volume of the RSS sound.
C-Lvl (Center Level) 0–100 Sets the volume for the center delay sound.
LF Damp Gain (LF-Damp Gain) -36–0 dB Sets the degree of attenuation in the low frequency band for the center delay sound returned to the
input.
LF Damp Freq (LF-Damp Frequency) 50–4000 Hz Sets the frequency at which attenuation in the low frequency band starts for the center delay sound
returned to the input.
HF Damp Gain (HF-Damp Gain) -36–0 dB Sets the degree of attenuation in the High frequency band for the center delay sound returned to
the input.
HF Damp Freq (HF-Damp Frequency) 1.0–20.0 kHz Sets the frequency at which attenuation in the High frequency band starts for the center delay
sound returned to the input.
FBLvl (Feedback Level) -100–100 Sets the amount of the center delay sound should be returned to the delay input.
FX Lvl (Effect Level) -100–100 Sets the volume of the delay RSS sound.
DirLvl (Direct Level) -100–100 Sets the volume of the direct sound.
Phones (Phones) Off, On Set to On when you use headphones *1
Set to Off when you use speakers
*1 Refer to the column “Precautions for using RSS” (p. 38).
* The location is fixed; no azimuth or elevation can be specified.
* Refer to the column “Labeling on RSS product package” (p. 38).
Output L
Output R
3 Tap Delay
Feedback Level
R ch Delay
L ch Delay
Center Delay
Direct Level
Direct Level
Input L
Input R
RSS
RSS
VS-2000_e.book 28 ページ ２００５年１２月１２日 月曜日 午後４時５４分