Roland VS-2000 - Page 32

32
Algorithm List
Chorus RSS
RSS (p. 37) is connected to the Chorus output. The sound image is defined with the sound from the left-side channel located at left
90˚ and the sound from the right-side channel at right 90˚.
fig.08-22
• Location is fixed; no azimuth or elevation can be specified.
• Refer to the column “Labeling on RSS product package” (p. 38).
Parameter (full name) Setting Function
ChoRSS (Chorus RSS) : Locates chorus sounds three-dimensionally.
Rate (Chorus Rate) 0.1–10.0 Hz Sets the rate of modulation.
Depth (Chorus Depth) 0–100 Sets the depth of modulation.
FX Lvl (Effect Level) -100–100 Sets the volume of the chorus RSS sound.
DirLvl (Direct Level) -100–100 Sets the volume of the direct sound.
Phones (Phones) Off, On Set to On when you use headphones *1
Set to Off when you use speakers
*1 Refer to the column “Precautions for using RSS” (p. 38).
Space Chorus
This is a chorus effect simulating Roland SDD-320. The effect to be changed can be reproduced by turning the four buttons 1 to 4
on or off.
fig.08-51
Parameter (full name) Setting Function
Spcho (Space Chorus): Adds a chorus effect simulating SDD-320.
Sw (Switch) On, Off Turns the space chorus on or off.
InMode (Input Mode) Mono, Stereo Specifies whether the input signal is stereo or mono.
Mode (Space Mode)
1, 2, 3, 4, 1+4, 2+4, 3+4
Sets the chorus variation style.
MixBal (Mix Balance) 0–100 Sets the volume balance between the chorus sound and the direct sound.
Input L
Input R
Chorus
Output L
Output R
Direct Level
Direct Level
RSS
RSS
Space Chorus
Input L
Input R
Output L
Output R
VS-2000_e.book 32 ページ ２００５年１２月１２日 月曜日 午後４時５４分