36
Algorithm List
Analog Flanger
Models Roland SBF-325 Analog Flanger. Provides three types of flanger effects as well as chorus-like effect.
fig.08-73
Parameter (full name) Setting Function
AFL (Analog Flanger): Models SBF-325 Analog Flanger.
Sw (Switch) On, Off Turns the analog flanger on or off.
Feedback (Feedback Level) 0–100 Sets the amount of the delayed sound should be returned to the flanger input. *1, *2
Modulation Freq (Modulation Frequency)
0–100 Sets the center frequency subject to application of the flanger effect.
Modulation Rate (Modulation Rate) 0–100 Sets the flanger’s modulation rate.
Modulation Depth (Modulation Depth) 0–100 Sets the depth of the flanger modulation.
Mode (Mode) FL1, FL2, FL3, CHO Sets the type of flanger effects. *3
ChB (Channel B Inverse) Nor, Inv “Inv” indicates that the Flanger effect on Channel B should be inverted. “Nor” indicates that it
should not be inverted.
Phase ChA (Mix A Inverse) Nor, Inv “Inv” indicates that the phase should be inverted for mixing Channel A Flanger sound into the
direct sound. “Nor” indicates that the phase should not be inverted.
Phase ChB (Mix B Inverse) Nor, Inv “Inv” indicates that the phase should be inverted for mixing Channel B Flanger sound into the
direct sound. “Nor” indicates that the phase should not be inverted.
*1: This feature is disabled when Mode is set to “CHO.”
*2: Excessively large values may cause oscillation.
*3: MODE is set to “FL1,” audio of Input R will not be send to Effect.
Rotary
Models a rotary speaker. Behaviors of High and low frequency band Roters can be set up separately, allowing realistic modeling of
unique surging sensation. This effect is suited for organ sounds.
fig.08-32
Parameter (full name) Setting Function
NS (Noise Suppressor): Mutes noise in the silent mode.
Sw (Switch) On, Off Turns the noise suppressor on or off.
Thresh (Threshold) 0–100 Sets the level to start muting noise.
Release (Release) 0–100 Sets the time over which the volume will drop to 0 after the noise starts being muted.
Ovd (Overdrive): Adds distortion to the sound.
Sw (Switch) On, Off Turns overdrive on or off.
Gain (Gain) 0–100 Sets the degree of sound distortion.
Level (Level) 0–100 Sets the volume of the overdrive sound.
Rot (Rotary Speaker): Models a rotary speaker.
LRate (Low Rate) 0.1–10.0 Hz Sets the rotary frequency of the low frequency band roter.
HRate (High Rate) 0.1–10.0 Hz Sets the rotary frequency of the High frequency band roter.
Analog
Flanger L
Analog
Flanger R
Input L
Input R
Output L
Output R
(Mode=FL2/FL3/CHO)
Analog
Flanger L
Analog
Flanger R
Input L
Input R
Output L
Output R
(Mode=FL1)
Types of Flanger Effect
Analog Flanger provides a variety of flanger effects or chorus effects. Selecting the desired flanger effect type in Mode.
FL1: General monaural flanger
FL2: Stereo flanger that allows stereo location of the direct sound to take effect.
FL3: Cross mix flanger that provides more powerful effect
CHO: Chorus effect
Over Drive Rotary Speaker
Output L
Output R
Noise Suppressor
Input L
Input R
VS-2000_e.book 36 ページ ２００５年１２月１２日 月曜日 午後４時５４分
To Next Page
Loading...
