45
Algorithm List
Dly(Delay):Adds a delayed sound to the direct sound, adding depth to the sound or creating special effects.
Sw (Switch) On, Off Turns the delay on or off.
Time (Delay Time) 0–1000 ms Sets the time from direct sound until when the delay sound is heard.
FBLvl (Feedback Level) -100–100 Sets the amount of the delay sound should be returned to the delay input.
FX Lvl (Effect Level) -100–100 Sets the volume of the delay sound.
DirLvl (Direct Level) -100–100 Sets the volume of the direct sound.
Cho (Chorus): Adds spaciousness and thickness to the sound.
Sw (Switch) On, Off Turns the chorus on or off.
Rate (Rate) 0.1–10.0 Hz Sets the rate of modulation.
Depth (Depth) 0–100 Sets the depth of modulation.
PreDLY (Pre-Delay) 0–50 ms Sets the time delay from when the direct sound begins until the processed sound is heard.
FX Lvl (Effect Level) -100–100 Sets the volume of the chorus sound.
DirLvl (Direct Level) -100–100 Sets the volume of the direct sound.
*1: If Low Type (Lo Type) or High Type (Hi Type) is set to “Shlv (Shlving Type),” the setting for Lo Q or High Q is invalid.
Voice Transformer
You can convert male voice into female voice, female voice into male voice, and human voice into mechanical voice to create sounds
of various qualities by controlling the base pitch and the formant separately.
fig.08-63
• When inputting voice, use voice of one person only. Inputting voices of more than one person disables normal operation.
• Be sure that sound from a speaker does not enter the microphone you are using. This will have the same effect as if several voices were input to the unit.
• A undirectional microphone is recommended for use. It is also recommended that the person should speak standing as close to the microphone as possible.
• “Voice Transformer” cannot be used on EFFECT2, 4, and 6 (even-numbered effects).
• When “Voice Transformer” is used on EFFECT1, 3, and 5 (odd-numbered effects), EFFECT2, 4, and 6 (even-numbered effects) cannot be used.
Parameter (full name) Setting Function
VT (Voice Transformer): Creates various voice characters.
Sw (Switch) On, Off Turns Vocal the transformer on or off.
Robot (Robot) On, Off When this is on, the audio will be output at a fixed pitch regardless of the pitch that is input.
Chromatic Pitch -12– +36 Sets the pitch variation of the voice to be output (by semitone).
Fine Pitch -100–100 Sets the pitch variation of the voice to be output (by cent).
Chromatic Formant -12– +12 Sets the formant variation of the voice to be output (by semitone).
Fine Formant -100– +100 Sets the formant variation of the voice to be output (by cent).
MixBal (Mix Balance) 0–100 Sets the volume balance between the output voice and the input voice.
REV (Reverb): Adds reverberation.
Sw (Switch) On, Off Turns the reverb on or off.
Time (Reverb Time) 0.1–32.0 sec Sets the length (time) of the reverb sound.
PreDLY (Pre-Delay) 0–200 ms Sets the time until the reverberation appears.
Densty (Density) 0–100 Sets the density of the reverb sound.
FX Lvl (Effect Level). 0–100 Sets the volume of the reverb sound.
Formants (p.12)
Voice
Transformer
Reverb
Input L
Input R
Output R
Output L
VS-2000_e.book 45 ページ ２００５年１２月１２日 月曜日 午後４時５４分
To Next Page
Loading...
