7
Troubleshooting
Can’t write to a CD-R/RW disc (Creating an audio CD)
❍
Is there sufficient free space on the internal hard disk?
➔
When you create an audio CD, an image file is created on the hard disk. The hard disk must have enough free
space to create this image file.
❍
Are you attempting to write tracks that exceed the free space on the CD-R/RW disc?
➔
The size of the tracks you are writing and the free space on the CD-R/RW disc are shown in the CD-R Write
screen.
❍
Are you attempting to write to an already-finalized CD-R disc?
Internal effects
Can’t use effects
❍
Can’t use EFFECT 3–EFFECT 6.
➔
Is the VS8F-2 (sold separately) installed?
With the standard internal effects, EFFECT 1/EFFECT 2 will be available. In order to use EFFECT 3–EFFECT 6,
you must install one or more VS8F-2 boards.
❍
For EFFECT 2/EFFECT 4 /EFFECT 6, are you attempting to select a patch that uses one of the following
algorithms?
Reverb/Gate Reverb/Vocoder 2 (19)/Voice Transformer/Mastering Tool Kit
❍
Has a patch using one of the following algorithms already been selected for EFFECT 1/EFFECT 3/EFFECT 5?
Vocoder 2 (19)/Voice Transformer/Mastering Tool Kit
❍
Could you be using RSS pan?
➔
RSS pan uses the built-in effect board to perform processing. This means that if in the RSS Pan Setup screen
you set “FX BOARD’A’ Use Sw” to “On,” EFFECT 1 and EFFECT 2 will not be available.
❍
Could you be using harmony?
➔
Harmony uses the built-in effect board and the VS8F-2 (sold separately) to perform processing. This means
that the number of effects corresponding to the number of harmony parts will be unavailable.
Can’t change the connection order of the effect algorithm
➔
You cannot change the connection order of the effect algorithm. You can only switch effects on/off. For the
connection order of each algorithm, refer to “Algorithm list” (p. 21).
USB connection
When connected to your computer via USB, the VS-2000’s internal
CD-RW drive is detected
➔
If this occurs, re-connect using one of the following methods (A–C).
Break the connection as described in “Terminating the connection to your computer” (Owner’s Manual),
and disconnect the USB cable.
Power-off the VS-2000,
and then turn it on again.
Power-off your computer,
and then turn it on again.
Once again, make connections as described in “Establishing a connection to your computer” (Owner’s
Manual).
VS-2000_e.book 7 ページ ２００５年１２月１２日 月曜日 午後４時５４分
To Next Page
Loading...
