8
Troubleshooting
MIDI devices
When the VS-2000 is the master, your MIDI sequencer doesn’t sync with it
❍
Is the MIDI cable connected correctly?
❍
Could the MIDI cable be broken?
❍
In the MIDI Parameter screen, could “MIDI OUT/THRU” be set to “Out”?
❍
In the Sync Parameter screen, is “MIDI OUT SYNC Gen.” selected correctly?
❍
Could the EXT SYNC indicator be blinking?
➔
The Sync Parameter screen’s “SYNC MODE” is set to “EXT.”
If you want the VS-2000 to operate as the master, set this to “INT.”
❍
Are the two devices using different types of MTC?
➔
In order to synchronize via MTC, the VS-2000 and your MIDI sequencer must be set to use the same type of
MTC.The VS-2000’s MTC is specified by the Sync Parameter screen’s “FRAME RATE” setting.
❍
Is MIDI clock data recorded in the sync track?
➔
If you want to use the sync track to synchronize the operation, you must first record MIDI clock data in the
sync track.
❍
Could the settings in your MIDI sequencer be incorrect?
❍
Is your MIDI sequencer in playback-ready mode?
The VS-2000 doesn’t sync with a MIDI sequencer when it’s the master
❍
Is the MIDI cable connected correctly?
❍
Could the MIDI cable be broken?
❍
Are you attempting to sync to MIDI Clock?
➔
The VS-2000 can operate as a slave only to MTC.
❍
Could the EXT SYNC indicator be dark?
➔
The Sync Parameter screen’s “SYNC MODE” is set to “INT.”
If you want the VS-2000 to operate as the master, set this to “EXT.”
❍
Are the two devices using different types of MTC?
➔
In order to synchronize via MTC, the VS-2000 and your MIDI sequencer must be set to use the same type of
MTC.The VS-2000’s MTC is specified by the Sync Parameter screen’s “FRAME RATE” setting.
❍
Could your MIDI sequencer be set inappropriately?
❍
Is the VS-2000 in playback-ready mode ([PLAY] blinking)?
❍
The incoming MTC may be of poor quality.
➔
In the Sync Parameter screen, try setting the “ERROR LEVEL” to 5 or higher. This may help.
Other
Buttons don’t work, or work in unexpected ways
❍
Could the System Parameter <1/3> screen’s “SHIFT LOCK” be turned “On”?
➔
If shift lock is on, pressing [SHIFT] will turn the shift button on (lit), and the state of [SHIFT] being held will
be maintained. In this state, only buttons that work in conjunction with [SHIFT] will function. Press [SHIFT]
once again to turn the shift button off (unlit).
VS-2000_e.book 8 ページ ２００５年１２月１２日 月曜日 午後４時５４分
To Next Page
Loading...
