26. “AUX Snd=” appears in the display. Rotate the
TIME/VALUE dial. If you wish to send the
track/source to the AUX bus, select either “Pre”
or “Pst,” and proceed to step 27. If you do not
wish to send the track/source to the AUX bus,
select “Off,” and proceed to step 31.
27.
Press PARAMETER [ ]. You can return to the
previous screen by pressing PARAMETER [ ].
28. “TR* SndLev =” appears in the display. Use the
TIME/VALUE dial to adjust the send level.
29.
Press PARAMETER [ ]. You can return to the
previous screen by pressing PARAMETER [ ].
30. “TR* SndPan” appears in the display. Use the
TIME/VALUE dial to adjust the send pan.
31.
Press PARAMETER [ ]. You can return to the
previous screen by pressing PARAMETER [ ].
32. “Master Sel=” appears in the display. Use the
TIME/VALUE dial to select the bus (MIX, AUX,
FX1, FX2, REC) that you wish to output from the
MASTER jacks.
33.
Press PARAMETER [ ]. You can return to the
previous screen by pressing PARAMETER [ ].
34. “EQ Sel=” appears in the display. Rotate the
TIME/VALUE dial.
35.
Press PARAMETER [ ]. You can return to the
previous screen by pressing PARAMETER [ ].
36. “Direct Out =” appears in the display. Rotate the
TIME/VALUE dial. If you do not wish to use
Direct OUT, select “Off.” If you wish to output
tracks 1–4, select “1-4.” If you wish to output
tracks 5–8, select “5-8.”
37.
Press PARAMETER [ ]. You can return to the
previous screen by pressing PARAMETER [ ].
38. “FX1 MstIns=” appears in the display. Rotate the
TIME/VALUE dial. If you wish to insert effect 1
into the master out, select “On.” If not, select
“Off.” If effect 1 has been inserted in another
channel, the display will indicate “—” and this
item cannot be set.
39.
Press PARAMETER [ ]. You can return to the
previous screen by pressing PARAMETER [ ].
To Next Page
Loading...
