57
Chapter 3: Recording Applications
(Loop Recording, Continued)
8. Find the LOOP end point by using fast forward to locate a point after the punch out location
(end of a Verse, Chorus etc.) and store this location in LOC 4 by pressing [LOC] 4 (the LED
will illuminate).
9. Press [LOCATOR] (under EDIT CONDITION-just under the LCD screen) repeatedly until
“LOC LpSt” is displayed.
Perform steps 10, 11, and 12 without releasing the [LOOP] button.
10. Press and HOLD the [LOOP] button (the one with the LED above it next to AUTOPUNCH),
during the next two steps.
11. Press the [LOC] 3 button where the LOOP start location is stored.
12. Press the [LOC] 4 button where the LOOP end location is stored.
You can then check the LOOP end point by pressing the right [PARAMETER>>]
button (LOC LpOt).
Alternate Method:
1. Alternately, you can enter the LOOP start and end locations manually while viewing their
respective screen displays by using the TIME/VALUE dial or [NUMERICS] buttons (for
more information on Numerics, see Owner’s Manual page 44).
To Next Page
Loading...
