Roland VXpanded VS-880 - Page 63

62
VS-880 Application Guide
(Sync To An External Sequencer Using MMC, Continued)
9.Using the [<<PARAMETER>>] buttons, scroll through the various screen pages and set each
parameter to the following:
MID:DeviceID= *
MID:MIDIThr= OUT
MID:SysEx.Rx= On
MID:SysEx.Tx= Off
MID:MMC= Slave
MID:CtrLocal= *
MID:CtrType= *
MID:P.C.Scne *
MID:P.C.Eff *
MID:C.C.Eff *
* These parameters do not apply to MMC Sync and are not used here.
THE EXTERNAL SEQUENCER SETUP
10. Set the sequencer to “MMC Master” mode.
11. Set it to slave to MTC (MTC slave mode).
12. Press “PLAY” on the external sequencer – OR – press [PLAY] on the VS-880.
MIDI Clock can also be used as the sync source in this example. Follow the instruc-
tions detailed in “Using MIDI Clock” on page 60 of this guide, along with the
instructions above.