Roland VXpanded VS-880 - Song Saving and Protection

73
Chapter 4: Overdub Applications
(Bouncing Tracks 1-6 To Tracks 7-8, Continued)
Using the INPUT MIX/TRACK MIX mode:
Use the following procedure to bounce tracks using the INPUT MIX/TRACK MIX mode:
A. Select TRACK MIX mode
1. Hold [SHIFT] and press [SELECT] (under MIXER MODE), to choose TRACK MIX mode.
B. Route Tracks 1 through 6 to buss 7-8
2. Press [CH EDIT] 1 to select Track 1.
3. Hold [SHIFT] and press [Input/BUSS] (CH EDIT button 1)
4. Use the TIME/VALUE dial to select “7-8” as the “BUSS SEL” for Track 1.
5. Press [CH EDIT] 2, select “7-8” as the “BUSS SEL” for Track 2.
6. Repeat steps 2-5 for Tracks 3, 4, 5, and 6.
C. Route tracks 7 & 8 to the MIX buss
7. Hold [SHIFT] and press [Input/BUSS] (CH EDIT button 1).
8. Press [CH EDIT] 7 to select Channel 7.
9. Use the TIME/VALUE dial to select “MIX” as the “BUSS SEL” for Track 7.
10. Repeat steps 8 and 9 for Track 8.
D. Record tracks 1 through 6 to tracks 7 & 8
11. Press the [TRACK STATUS] buttons on Tracks 7-8 until they are flashing red (record ready
mode).
12. Make sure that channels 1-6 are in “PLAY” mode (green LED).
13. Adjust the faders, pans and effects of tracks 1-6 as needed.
14. Press [REC] followed by [PLAY] to record the bounce.