Roland VXpanded VS-880 - Chapter 4: Editing Recorded Performances (Track Editing); Finding Locations and Basic Editing Procedures

75
Chapter 4: Overdub Applications
18. Press the right [PARAMETER>>] button again and use the TIME/VALUE Dial to set the Pan
position.
The effects will now be routed to tracks 7-8 and will be recorded along with the source tracks 1-6.
E. Route tracks 7 & 8 to the MIX buss
19. Hold [SHIFT] and press [Input/BUSS] (CH EDIT button 1).
20. Press [CH EDIT] 7 to select Track 7.
21. Use the TIME/VALUE dial to select “MIX” as the “BUSS SEL” for Track 7.
22. Repeat steps 8 and 9 for Track 8.
F. Record tracks 1 through 6 to tracks 7 & 8
23. Press the [TRACK STATUS] buttons on Tracks 7-8 until they are flashing red (record ready
mode).
24. Make sure that channels 1-6 are in “PLAY” mode (green LED).
25. Adjust the faders, pans and effects of tracks 1-6 as needed.
26. Press [REC] followed by [PLAY] to record the bounce.