21.Press PARAMETER [ ]. The display will indicate “EFF1 RTN Bal=”.
22.. Adjust the left/right volume balance of effect 1. Rotate the TIME/VALUE dial.
EFF1 Bal (Effect 1 balance)
Set the left/right volume balance (L63Ð0ÐR63) of effect 1.
23.Press [EFFECT] several times until the display reads “EFF EFFECT-1 PRM ?”.
24.. Press [YES].
25.Select effect 1. Rotate the TIME/VALUE dial. For this example, select an effect such as A00
RV:LargeHall.
26.Press [YES].
27.Set the track status of tracks 7 and 8 to REC.
When you begin recording, the direct sound and reverb sound will be recorded.
If the effect does not sound as you expect
¥ Is a signal being sent to the EFFECT buss?
¥ Is the send level to the effect raised?
¥ Is the return level from the effect raised?
¥ Is the return from the effect set correctly?
¥ Is the effect level raised?
¥ Is the direct level raised?
¥ Are the left/right channels inserted correctly?
¥ Is the send level to the effect raised for each channel?
¥ Is the master send level to the effect raised?
Chapter 8 Using the internal effects
108
To Next Page
Loading...
