Safety Checklist
•
Test front and rear brakes for proper function.
•
Ensure brake pads are not over-worn and are correctly positioned in relation to rims.
•
Check that brake control levers are lubricated and tightly secured to handlebars.
•
Inflate tires to within recommended limits displayed on sidewalls.
•
Check for bulges or signs of excessive wear.
•
Clean tires to ensure tread is exposed.
•
Ensure rims run true and have no obvious wobbles or kinks.
•
Check that all wheel spokes are tight and not broken.
•
Check the wheel balance in Pedal Only Mode. If you notice the riding is imbalanced or the rotation of the front wheel makes noise, it means the bolts were not
completely tightened or not aligned horizontally.
•
Check that chain is oiled, clean and runs smoothly.
•
Use extra care in wet or dusty conditions.
•
Securely tighten pedals to cranks.
•
Ensure cranks are securely tightened and are not bent.
•
Check that derailleur(s) are adjusted and functioning properly.
•
Ensure shift and brake levers are attached to handlebar securely.
•
Check all brake and shift cables for proper lubrication.
•
Ensure hub motor is spinning smoothly and motor bearings are in good working order.
•
Check that all power cables running to hub motor are secured and undamaged.
•
Make sure hub motor axle bolts are secured and all torque arms and torque washers are in place.
•
Ensure battery is charged before use.
•
Check for any visible damage to battery pack.
•
Lock battery securely to frame.
•
Charging: Plug in the charger first, and then plug the power supply.
To Next Page
Loading...